PROMOTE MY BLOG: JUST CLICK BELOW BUTTON

Search Any Paper On This Blog

Thursday, February 24, 2011

CS601 Solved Final Term Fall 2010 Current Paper

question No: 1 ( Marks: 1 ) - Please choose one
Which is not an element of protocol
semantics
timing
 communication service module

Question No: 2 ( Marks: 1 ) - Please choose one
Layers 5, 6 and 7 also called as network support layers.
 True
False
Question No: 3 ( Marks: 1 ) - Please choose one
Fourier transform tells us that any digital signal can be decomposed into infinite number of periodic signals
 True
False
Question No: 4 ( Marks: 1 ) - Please choose one
Time domain plot show changes in signal phase with respect to time.
 True
False
Question No: 5 ( Marks: 1 ) - Please choose one
Analog to digital conversion is also termed as modulating an analog signal.
True
 False


Question No: 6 ( Marks: 1 ) - Please choose one
DC component is also termed as Direct current component or a component with non-zero frequency.
False
 True


Question No: 7 ( Marks: 1 ) - Please choose one
Manchester is a type of ____________encoding.
 biphase
polar
biphase & polar
none of the given
www.allvupastpapers.blogspot.com



Question No: 8 ( Marks: 1 ) - Please choose one
The inversion of the level at 1 bit is called as __________

NRZ-L
 NRZ-I
RZ
Question No: 9 ( Marks: 1 ) - Please choose one
PCM is the first process of PAM.
True
 False


Question No: 10 ( Marks: 1 ) - Please choose one
In 4PSK each phase change represents ______bits.
3
6
 2
4


Question No: 11 ( Marks: 1 ) - Please choose one
In RS 422 Balanced mode two lines carry ________ signals which are not identical to each other.
 same
different
digital
analog
www.allvupastpapers.blogspot.com

Question No: 12 ( Marks: 1 ) - Please choose one
A ______________ converts an analog signal into a digital signal. 
Demodulator
Modulator
Digital-to-analog converter
Question No: 13 ( Marks: 1 ) - Please choose one
Which of the following is an example of ITU-T modem standards:
T-series
X-series
N-series
 V-series



Question No: 14 ( Marks: 1 ) - Please choose one
The maximum data rate in the uploading direction is still ____________.

26.6 Kbps
 33.6 Kbps
36.6 Kbps
46.6 Kbps
www.allvupastpapers.blogspot.com

Question No: 15 ( Marks: 1 ) - Please choose one
Which of the following primarily uses guided media
Cellular telephone system
 Local telephone system
Satellite communication
Radio broadcasting



Question No: 16 ( Marks: 1 ) - Please choose one
When a beam of light travels through media of two different densities, if the angle of incidence is greater than the critical angle, ____________occurs.
 Reflection
Refraction
Incidence
Criticism



Question No: 17 ( Marks: 1 ) - Please choose one
When we talk about unguided media, usually we are referring to _________.

Metallic wires
Nonmetallic wires
 The air
Water


Question No: 18 ( Marks: 1 ) - Please choose one
Optical fibers are defined by the ratio of the ___________ of their core to the diameter of their cladding.
 Diameter
Radius
Length
Width

www.allvupastpapers.blogspot.com

Question No: 19 ( Marks: 1 ) - Please choose one
All of popular Fiber optic connectors are ___________ shaped.
Conical
 Barrel
Circular
Rectangular



Question No: 20 ( Marks: 1 ) - Please choose one
Radio wave transmission utilizes ___________ different types of propagation.
Four
Three
Two
 Five


Question No: 21 ( Marks: 1 ) - Please choose one
dB is ____________ if a signal is amplified.
 Negative
Positive
Null
Zero
www.allvupastpapers.blogspot.com

Question No: 22 ( Marks: 1 ) - Please choose one
A prism can deflect the light depending upon the angle of ____________ and the frequency.

 Deviation
Incident
Refraction
Reflection


Question No: 23 ( Marks: 1 ) - Please choose one
Asynchronous TDM is efficient only when the size of the time slot is kept relatively _______________
 Large
Small
Medium
None of the given



Question No: 24 ( Marks: 1 ) - Please choose one
The local loop has ___________ cable that connects the subscriber telephone to the nearest end office.
 Twisted-pair
Coaxial
Fiber-optic
None of the given
www.allvupastpapers.blogspot.com

Question No: 25 ( Marks: 1 ) - Please choose one
Data from a computer are ____________; the local loop handles _________ signals.
Analog; analog
Analog; digital
Digital; digital
 Digital; analog


Question No: 26 ( Marks: 1 ) - Please choose one
Which error detection method uses ones complement arithmetic?
Simple parity check
Two-dimensional parity check
CRC
 Checksum
Question No: 27 ( Marks: 1 ) - Please choose one
Flow control is needed to prevent ____________
Bit errors
 Overflow of the sender buffer
Overflow of the receiver buffer
Collision between sender and receiver
www.allvupastpapers.blogspot.com

Question No: 28 ( Marks: 1 ) - Please choose one
____________ coordinates the amount of data that can be sent before receiving acknowledgment
flow control
error control
data control


Question No: 29 ( Marks: 1 ) - Please choose one
Error control is both error _________ and error ___________
detection; correction
detection; deletion
detection; avoidance
detection; forwarding


Question No: 30 ( Marks: 1 ) - Please choose one
Addressing is not needed in _______________ configuration.
Point to Point
Multipoint
Point to point and multipoint
www.allvupastpapers.blogspot.com

Question No: 31 ( Marks: 1 ) - Please choose one
In a Go-Back-N ARQ, if the window size is 63, what is the range of sequence number?
 0 to 63
0 to 64
1 to 63
1 to 64



Question No: 32 ( Marks: 1 ) - Please choose one
A timer is set when ___________ is sent out.
A data frame
 An ACK
A NAK
www.allvupastpapers.blogspot.com

Question No: 33 ( Marks: 1 ) - Please choose one
Sliding window requires that data frames be transmitted _______________
 Sequentially
Frequently
Synchronously
Asynchronously


Question No: 34 ( Marks: 1 ) - Please choose one
In Y-MODEM Multiple files can be sent simultaneously
 True
False



Question No: 35 ( Marks: 1 ) - Please choose one
BLAST stands for :
 Blocked asynchronous transmission
Blocked synchronous transmission
Barrel asynchronous transmission
Below asynchronous transmission
www.allvupastpapers.blogspot.com


Question No: 36 ( Marks: 1 ) - Please choose one
HDLC is an acronym for ______________.
High-duplex line communication
 High-level data link control
Half-duplex digital link combination
Host double-level circuit


Question No: 37 ( Marks: 1 ) - Please choose one
The HDLC ___________ field defines the beginning and end of a frame.

 Flag
Address
Control
FCS
www.allvupastpapers.blogspot.com

Question No: 38 ( Marks: 1 ) - Please choose one
_________ is the access protocol used by traditional Ethernet.
 CSMA/CD
CSMA/CA
Token Ring
CSMA


Question No: 39 ( Marks: 1 ) - Please choose one
Bridges can divide a large ________ into smaller segments
 Network
Packet
Frame
Address


Question No: 40 ( Marks: 1 ) - Please choose one
Like VRC, LRC and CRC, Checksum is also based on _______________.
 Redundency
Decimal Division
Encryption
Encoding
www.allvupastpapers.blogspot.com

Question No: 41 ( Marks: 2 )
What are the conditions for the polynomial used by the CRC generator?
CRC generator:
CRC generator (the divisor) is most often represented not as a1’s and 0’s but as an algebraic polynomial.
conditions for the polynomial:
it should have following properties:
It should not be divisible by “x”.
It should not be divisible by “x+1”.
The first condition guarantees that all burst error of a length equal to degree of the polynomial is detected.
The 2nd condition guarantees that all burst error affecting an odd number of bits are detected.

Question No: 42 ( Marks: 2 )
What are intelligent modems?
Intelligent modems:
A modem that responds to commands and can accept new instructions during online transmission. It was originally developed by Hayes.
Example:
• Automatic answering,
• Dialing etc.
www.allvupastpapers.blogspot.com

Question No: 43 ( Marks: 2 )
What is the basic purpose of Router?
Basic purpose of Router:
"A router is a device that extracts the destination of a packet it receives, selects the best path to that destination, and forwards data packets to the next device along this path. They connect networks together;
a LAN to a WAN for example, to access the Internet. 
"A more precise definition of a router is a computer networking device that interconnects separate logical subnets."
Question No: 44 ( Marks: 3 )
What are the fractional T Lines?
The fractional T Lines:
Many subscribers don’t need the entire capacity of the T-line. 
For example,
A small business may need only one-fourth of the capacity of T-line. if four business of same size lie in the same building, they can share T-line.DSU/CSU allow the capacity of T-line to be interleaved in to four channels

Question No: 45 ( Marks: 3 )
What are the light sources used for optic fiber?
• light sources used for optic fiber:
• The light source can weather be an LED or ILD 
• LED (Light emitting diode) cheaper but provide unfocused light that strikes the boundaries of channel at uncontrollable angles.
• Limited to short distance use.
• LASSER 
• Can be focused to a narrow range allowing control over angle of incidence.
www.allvupastpapers.blogspot.com

Question No: 46 ( Marks: 3 )
What is Multi Access Unit (MAU) in Token Ring?
Multi Access Unit (MAU) in Token Ring:
• Individual automatic switches are combined in to a hub
• One MAU can support up to 8 stations.
• Although it looks like a star, it is in fact a ring.


Question No: 47 ( Marks: 5 )
Give characteristics of Dual Ring, if necessary then draw the diagram. [5]
Characteristics of Dual Ring:
A network topology in which two concentric rings connect each node on a network instead of one network ring that is used in a ring topology. Typically, the secondary ring in a dual-ring topology is redundant. It is used as a backup in case the primary ring fails. In these configurations, data moves in opposite directions around the rings. Each ring is independent of the other until the primary ring fails and the two rings are connected to continue the flow of data traffic.

www.allvupastpapers.blogspot.com

Question No: 48 ( Marks: 5 )
What the receiver will receive if the checksum method is applied to the following 
bit.
10101001 00111001
Ans:
the receiver will receive the checksum method is applied to the following bit.
10101001 00111001
10101001 00111001
Sum of 2 bits are
10101001
00111001
-------------------
11100010
00011101 1's complement
1
--------------
00011110 2's complement
-----------
10101001 00111001 ==> 00011110
So the data transmitted which will receiver get:
10101001 00111001 00011110
Question No: 49 ( Marks: 5 )
What is rafraction in terms of optic fiber? Give one example.
Refraction:
Light travels in a straight line as long as it is moving through a single uniform structure If a ray of light traveling through one substance enters another (more or less dense) substance, its speed changes abruptly causing the ray to change direction. This phenomenon is called Refraction.
Refraction in terms of optic fiber:
www.allvupastpapers.blogspot.com

the propagation of light in an optical fiber which in its simplest form consists of a circular core of uniform refractive index surrounded by a cladding of slightly lower refractive index. The light is launched into the entrance face of the fiber. 
The light is propagated by the total internal reflection at the interface between core and cladding. However the rays incident at angles larger than a certain angle, called the cut-off angle, suffer both refraction and reflection at the interface between the core and the cladding. 
They, therefore, are not guided. Due to this the optical fiber has a numerical aperture. The numerical aperture is given by the square root of (n12-n22). Typical values of numerical aperture lie between 0.1 and 0.3.
The refractive indices of the core and the cladding are n1 and n 2 respectively. The fiber is normally in air (n0=1) but could also be in a medium of refractive index n0.
www.allvupastpapers.blogspot.com

Question No: 50 ( Marks: 10 )
What are the asynchronous protocols in data link layer? Discuss in detail with examples. [10 marks]
Asynchronous protocols in data link layer:
Asynchronous communication at the data link layer or higher protocol layers is known as statistical multiplexing or packet mode communication,
For example :
Asynchronous transfer mode (ATM). In this case the asynchronously transferred blocks are called data packets, 
Async protocols in Data link layer is called statistical multiplexing. for example ATM cells.
The opposite is circuit switched communication, which provides constant bit rate, for example ISDN and SONET/SDH.
The packets may be encapsulated in a data frame, with a frame synchronization bit sequence indicating the start of the frame, and sometimes also a bit synchronization bit sequence, typically 01010101, for identification of the bit transition times. Note that at the physical layer, this is considered as synchronous serial communication.
Examples of packet mode data link protocols that can be/are transferred using synchronous serial communication are the 
• HDLC,
• Ethernet,
• PPP and 
• USB protocols.


By ADEEL ABBAS, Bhakkar. AdeelAbbasbk@gmail.com

No comments:

Post a Comment

PLEASE COMMENT ABOUT YOUR VISIT AND MY SITE

Note: Only a member of this blog may post a comment.